Or call our technical support: +31852080825

Available Monday through Friday from 7AM to 3:30PM CET
Please create a ticket before calling and keep the ticket number at hand.
At the moment we are only offering support in English, so we kindly ask you to address your issue in English.
Start a new topic

Issues attempting to use 'Vase' mode printing from Simplify 3D on my Creatr HS

Hi all,

I tried to print a small vase (maybe bowl) -like model for a test and did not have a lot of success.. 

I am printing Black PLA with the usual parameters (190deg Extrusion, 45deg bed temp, then bed 0 deg after layer 5).

The end result was that the printer could not complete the print in a the center of the part, see photo; does anyone have / had this problem with their Creatr HS printing from Simplify 3D?

In addition to this issue I could not get the wall thickness to print correctly and have not a clue why at present... I assume perhaps it is just a setting but which one? I'be grateful if someone would kindly enlighten me.

Thanks in advance for any help.

Kind regards,


Login or Signup to post a comment

User Manual

Filament Guide

  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Xeed Video Library