Or call our technical support: +31852080825

Available Monday through Friday from 7AM to 3:30PM CET
Please create a ticket before calling and keep the ticket number at hand.
At the moment we are only offering support in English, so we kindly ask you to address your issue in English.
Start a new topic

Disappointing printer and support quality

 To whom it may concern,

over the past 4 months we have been struggling with Leapfrog and the Creatr HS. It took Leapfrog 3 1/2 months only to acknowledge that our Creatr HS has indeed a mechanical failure and supply us with an exchange printer.

This printer was printing extraordinary, for one week.

After that without any warning it stopped in the middle of a print, losing the connection to the computer. A new print lead to the printer moving into the glass bed since the z-axis end switch was not detected. This caused the switch to bend and the nozzles to break (the tip got pushed inside). After purchasing two new nozzles I cannot get the nozzles to be tight. There was no documentation or tips on how to mount the nozzles led alone how much torque is necessary or if additional sealing liquid is necessary.

After 4 months my conclusion to Leapfrog and the printer is that the concept is good but there are many many parts of the printer who needs to be redesigned. As well the support from Leapfrog is more than frustrating and unhelpful. I cannot count how many e-mails I wrote to get a solution, help or even an answer!.

We were planning to use this printer commercially in our company and after the replacement we had promising results. But at this point with the troubles starting all over again with a new printer we do not see a future neither for the printer nor for Leapfrog products in our company.

Attached you see a good result of the quality you get for about 2500€ when purchasing a Creatr HS. The fan nozzle has been melted already when we received the printer. And the nozzle itself looks like Leapfrog does not even have their own printer under control.

Kind regards


Login or Signup to post a comment

User Manual

Filament Guide

  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Xeed Video Library