What a disappointment !!
After spending over 3000 Euros on the printer and filaments.
After two days of average printing, the Leapfrog Creatr HS is not extruding material while printing in spite the fact that Loading and unloading of the filament works.
Even the first prints I made before this problem were not printing anymore.
The hot ends head moves but nothing is coming out!
Sometimes the filament piles up behind the bearing of the feeder motor and it takes a lot of effort to get it out.
Has any one had similar problems?
I doubt that any body from Leapfrog will respond to this.
Two days ago I sent an email to sales with several grievances and until now there is no response from the technical / support department.
Mr. Hossam, I reply to your ticket. Please check the answer and the solutions I gave you and let me know how if it works!
Please request a firmware download via the Ticket System